Crankshaft Front And Rear Oil Seal; Crankshaft Lubrication Ducts; Crankshaft Timing Gear - Kohler LAMBARDDINI LDW 1503 Workshop Manual

83
85
86
Workshop Manual LDW CHD _ cod.
Disassembly / Reassembly
84
ED0053031210 - 1° ed_rev. 00

Crankshaft front and rear oil seal

The front oil seal A is located in the oil pump cover while the
rear oil seal ring B, is positioned in the flange on the flywheel
side.
Replace seals if warped, hardened or damaged.
In case of replacement:
• Carefully clean the seat.
• Soak the seal in engine oil for approximately half an hour.
• Fill the inside with grease and lubricate and sealing lip with
thick oil.
• Drive the seal into its seal exerting a uniform pressure over
the entire front area.
Warning: In case of room temperature below -35°C seals could
become damaged.

Crankshaft timing gear

If gear A has to be replaced, use a bearing puller to remove it.
To reassemble it, you need to heat it up to a temperature of 180°
÷ 200°C and then fit it snugly.

Crankshaft lubrication ducts

Important
• During repair operations, when using compressed air, wear eye
protection.
Dip crankshaft into a bath (use a cleaning product).
Remove plugs and clean ducts A, B and C with a pointed tool.
Finally blow with compressed air.
Re-place plugs using a calking tool and check for sealing.
4
- 55 - - 55 -