Specifications - Makita HP1640 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Lamp
3-1. Reversing switch
4-1. Action mode changing lever

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of the
same voltage as indicated on the nameplate, and can only
be operated on single-phase AC supply. They are double-
insulated in accordance with European Standard and can,
therefore, also be used from sockets without earth wire.
For Model HP1640,HP1641,HP1641F
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode: impact drilling into concrete
Vibration emission (a
Uncertainty (K) : 2.0 m/s
Work mode : drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
5-1. Side grip
6-1. Chuck key
7-1. Sleeve
7-2. Ring
8-1. Depth gauge
Model
Concrete
Steel
Wood
-1
)
Blows per minute
Overall length
Net weight
Safety class
noise level determined
) : 92 dB (A)
pA
) : 103 dB (A)
WA
value (tri-axial vector
2
) : 19 m/s
h,ID
2
2
) : 2.5 m/s
h,D
2
ENE039-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENF002-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
ENG102-3
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
ENG203-2
Makita declares that the following Machine(s):
sum)
Designation of Machine:
Hammer Drill
Model No./ Type: HP1640,HP1641,HP1641F
Conforms to the following European Directives:
2006/42/EC
ENG301-1
They are manufactured in accordance with the following
Standard or standardized documents:
EN60745
3
8-2. Side grip
8-3. Grip base
10-1. Blow-out bulb
HP1640/HP1640F/HP1641/HP1641F
16 mm
13 mm
30 mm
0 - 2,800
0 - 44,800
303 mm
2.0 kg
/II
ENG901-1
ENH101-17