Advertisement
ADJUST PARKING BRAKE
Unit is equipped with two parking brake
cables that independently control parking
brake on each drive wheel.
1. Place unit in service position. See
Service Position on page 23.
2. Check parking brake. See Check Parking
Brake on page 28.
See Figure 42.
3. Loosen jam nuts on cable adjustment
barrel.
4. Adjust parking brake cable(s).
• To increase brake response on one or
both sides, loosen front jam nut(s) and
tighten rear jam nut(s).
• To decrease brake sensitivity on one or
both sides, loosen rear jam nut(s) and
tighten front jam nut(s).
5. Check parking brake and readjust if
necessary.
IMPORTANT: Make sure both parking brake
cables are within adjustment range.
1. Cable Adjustment Barrel
Figure 42
1
REPLACE MOWER BELTS
CAUTION: Damaged or worn
belts may result in injury and / or
damage to the unit. Check belts
for excessive wear or cracks
often.
Remove PTO Belt
See Figure 43.
1. Place steering levers in neutral position
and engage parking brake.
2. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
3. Position mower deck at lowest cutting
height.
4. Move seat to rearmost position.
5. Remove belt cover.
6. Open access panel.
2
1. Belt Cover
2. Access Panel
CAUTION: Use care when
releasing idler spring tension.
Keep body parts away from
idlers when performing this
operation.
EN - 34
1
Figure 43
Advertisement
