Recirculation Operation On Demand / Schedule Mode - Rheem Iconic RTGH-S11i Training And Service Manual

GENERAL INFORMATION
4. The Factory setting is " None ". Press the " ▼ "
or " ▲ " button until " On Demand " is displayed,
and press "ENTER" to confirm. To exit this setting,
press "BACK" button until the initial screen is dis-
played.
None
BACK ENTER
STATUS SERVICE MODE
RECIRCULATION OPERATION ON
DEMAND
The following accessories are needed to use the On
Demand recirculation activation.
RHEEM PART
NUMBER
SP20862
SP20863
When set to "On Demand" mode, the recirculation
pump is ON for 5 minutes when the signal from the Mo-
tion Sensor or Wired Push Button is received, or until
the return water temperature reaches approximately
15°F below the setting temperature.
SET POINT
For information about On Demand accessories, refer to
ENTER
STATUS SERVICE MODE
"If You Need Service" in the U&C Manual, "Call For As-
sistance" for the telephone number to speak to a Cus-
tomer Service Representative in the U&C manual.
OFF
BACK
On Demand
SETTINGS STATUS
BACK ENTER
SETTINGS STATUS SERVICE MODE
SET POINT
BACK
SETTINGS
DESCRIPTION
Motion Sensor Kit
Wired Push Button
Tankless Config
BACK
SETTINGS STATUS
BACK
SETTINGS
25
1.6.5.1.3 SCHEDULE MODE
1. Press the " SETTINGS " button.
ENTER
SERVICE MODE
2. Press the " ▼ " or " ▲ " button until "Tankless Con-
fig" is displayed, and press the "ENTER" button.
ENTER
STATUS SERVICE MODE
3. Press the " ▼ " or " ▲ " button until "Recirc. Pump
Modes" is displayed, and press "ENTER" to con-
firm.
ENTER
SERVICE MODE
None
ENTER
STATUS SERVICE MODE
IKONIC Tankless Water Heater Service Manual
SET POINT
BACK ENTER
SETTINGS STATUS SERVICE MODE
Tankless Config
BACK ENTER
SETTINGS STATUS SERVICE MODE
Recirc.Pump Modes
BACK ENTER
SETTINGS STATUS SERVICE MODE
OFF
BACK ENTER
SETTINGS STATUS SERVICE MODE
R
S
B
SE