Rimage Producer 7100 User Manual page 19

6. Align the printer.
a. Slowly move the lift arm down until the disc touches the recessed print pad.
Printer
Button
Side to Side
Alignment
Print Pad
b. If the disc is not centered side to side on the print pad, align the printer side to side.
i. Loosen the side to side screws.
ii. Slide the printer, not the printer tray, until the disc
is centered side to side on the print pad.
iii. Tighten the side to side screws.
c. If necessary, align the printer front to back by turning the front to back alignment screw until the gap
between the raised edge of the disc retainer and the disc is correct.
Everest: 1/16" gap at the front
Disc
Retainer
7. Raise the lift arm out of the way of the printer tray.
8. Press the printer button. The printer tray closes.
9. Press the disc release button. The gripper releases the disc.
Tip: Place your hand under the disc to catch it.
10. Close the front door. The printer is ready for use.
2000538_B
Maintain the Producer III Autoloader
Prism: Disc hangs over the front edge of the print pad
by 0.010" – 0.015"
Print
Pad
Gap
Lift
Arm
Holding Pins
Side to Side Screws
Front to Back Screw
17