ADTRAN 1200487G80 Manual

CLEI: BVL3ALHD_ _
Product P/N: 1200487G80
D
ESCRIPTION
The Small Form-Factor Pluggable (SFP) Gigabit Ethernet,
Single-Fiber is a bidirectional SFP that plugs into an
Optical Line Terminal (ONU) designed to accept SFPs. The
SFP provides a single optical interface to the GigE physical
interface. Installed into an appropriate ONU, the SFP
provides a Gigabit Ethernet interface to the supporting
system.
NOTE
To ensure compatibility, refer to the documentation
provided with the ONU.
NOTICE
In a deployment consisting of an OLT with a 1442180G1
SFP installed; the Network Unit (ONT) should have a
complementary 1200487G80 SFP installed.
Rx: 1490 nm
OLT
Tx: 1550 nm
1442180G1
The following features are supported on the SFP:
1000Base-LX 1490 nm Transmitter
♦
♦ 1000Base-LX 1550 nm Receiver
♦ Optical distance: 80 km maximum
!
CAUTION
Due to compliance certification requirements, only SFPs
supplied by ADTRAN should be used. ADTRAN cannot
certify system integrity with other SFPs.
Small Form-Factor Pluggable
1490 nm TX / 1550 nm RX, 80 km
Rx: 1550 nm
ONU
Tx: 1490 nm
1200487G80
Operational Specifications
♦ Optical Specifications:
◊ Transmit wavelength: 1490 nm
◊ Receive wavelength: 1550 nm
◊ Optical transmit level: –2 dBm to +3 dBm
Optical receive level: –25 dBm to –3 dBm
◊
Optical distance: 80 km
◊
◊ Optical connectors: LC
♦ Extended Environmental Support:
◊ Operational temperature range: –40°C to +70°C
◊ Storage temperature range: –40°C to +85°C
◊ Relative humidity to 95%, noncondensing
I
NSTALLATION
Prior to installation, inspect the SFP. If damage has occured
during shipping, file a claim with the carrier, and then
contact ADTRAN Customer Support. For more infor-
mation, refer to "Warranty".
To install the SFP into an appropriate module, complete
the following steps:
1. Insert the SFP into the SFP cage on the circuit board of
the host module with the latch handle facing outward.
Slide the SFP all the way into the cage.
NOTE
The latch on the SFP is for removal only. When removing
the SFP, rotate the latch away from the SFP, the SFP should
slide easily out of the cage.
2. Exert adequate pressure to ensure the SFP is
completely seated in the SFP cage.
3. Do not remove the connector plug until the optical
fiber connection is made.
NOTICE
It is recommended that the connector plug remain on
whenever the transciever optical fiber connector is not
inserted.
4. Continue the installation and turn-up of the host
module using the instructions in the Job Aid provided
with the module, or using the Installation and
Maintenance Guide (I&M) available online at
www.adtran.com.
jobAid
Issue Date: January 2011
Document P/N: 61200487G80-22A