LENCO DIR-140 User Manual page 10

10. Play/pause button
11. Mode buttton
12. Home button
13. Navigate Up button
14. Navigate Left button
15. Navigate Right button
16. Navigate Down button
17. OK button
18. VOL- button
19. VOL+ button
20. Input letters and numbers
21. FAV button
22. FAV+ button
Note: the cursor buttons (14,15) on the remote control can also be used to
navigate through the system menus.
Note:
WiFi allows data transfer over short distances within 20 meters without the need of cabling
between the devices. Walls/cellings may reduce the strength of the WiFi csignal.
Therefore try to locate the Lenco DIR-140 (V2) and/or the access point within the distance
mentioned
Above,and avoid obstacles between the devices.
Make sure you are connecting to a 2.4Ghz Wifi network (this device is not compatible with 5 Ghz
Wifi networks)
INITIAL SETUP
Before operation, please make sure that the voltage mentioned on the power supply is the same as
the voltage of your local area.
Use the supplied mains adaptor to connect the device to your household mains socket.
Insert the power adaptor into the DC IN (13) on the back to power up.
At the first startup, The Lenco DIR-140 (V2) the system start with the Wifi setup wizard.
10