Display Calibration Screens - Raymarine Verado Installation And Commissioning Manual

38
To prevent accidental access, we have made entry to Dealer Calibration more difficult than the
Note:
other groups. After pressing auto, the display will show CAL ?. When you see this, press the -1 and +1
keys together to enter Dealer Calibration.
4. When you have entered one of the Calibration groupings, press disp key to scroll down
through the items within that grouping.
You can go backwards through the list by pressing and holding the disp key for one second.
Note:
5. When you reach an item you wish to adjust, use the -1, +1, -10 and +10 keys to change
the value.
6. If you then want to adjust settings in another Calibration group, press standby and then
repeat steps 2 to 5 as necessary.
7. When you have made all the changes you want to make, press and hold standby for two
seconds to exit Calibration mode and save changes.

Display calibration screens

Display bar selection
This screen allows you to select what information is displayed at the bottom of the SmartPilot
display.
Options
RUDD BAR (Default)
STEER BAR
BAR OFF
Heading selection
This screen allows you to display any heading as either a magnetic or true value. During
normal SmartPilot operation the screen will indicate MAG for magnetic headings and TRUE
for true headings.
SmartPilot Verado Installation and Commissioning Guide
Rudder position bar. It uses the bar graph to show the true rud-
der angle. Requires rudder position sensor for accurate rudder
information.
The Verado system does not require a rudder position sensor.
Rudder position is sensed electronically and indicated on the
controller display only when the controller is in Auto mode.
This setting uses the bar graph to indicate different information
in different operating modes:
STANDBY: No rudder display (Verado)
AUTO: heading error bar (in 2° increments)
TRACK: cross track error (XTE) bar (in 0.02 nm increments)
WIND VANE: wind angle error bar (in 2° increments)
No bar is displayed