Smartpilot Settings; Calibration Basics - Raymarine Verado Installation And Commissioning Manual

36 SmartPilot Verado Installation and Commissioning Guide

SmartPilot settings

This chapter explains all the calibration settings you can adjust on the SmartPilot S1G course
computer. You will have adjusted many of these settings when commissioning the system,
and they should not require further adjustment.

Calibration basics

The Calibration mode has four calibration groups:
Display Calibration (DISPLAY CAL)
The items in Display Calibration affect the individual controller. They are stored in the
controller and do not affect any other controllers connected through SeaTalk.
You can adjust the Display Calibration settings as often as necessary – for example, to add or
change information displayed on data pages.
User Calibration (USER CAL)
The items in User Calibration vary according to the Vessel Type you have selected in Dealer
Calibration.
You will probably need to access User Calibration on a fairly regular basis to adjust SmartPilot
settings in response to changing conditions.Details on User Calibration can be found in the
SmartPilot Controller Operation Manual.
Seatrial Calibration (SEATRIAL CAL)
The Seatrial Calibration group is specifically designed for use during the initial seatrial (see
page 41
for full details).
You should not need to access Seatrial Calibration during normal operation.
Dealer Calibration (DEALER CAL)
The Dealer Calibration group includes items that have a significant impact on operation and
can affect your boat's safety.
After you have completed the initial installation and seatrial, you should not normally need to
alter the Dealer Calibration values. The items in Dealer Calibration vary according to the
Vessel Type you have selected.