•
Using the two perviously removed screws (6), attach
right-hand bagger latch assembly to the backplate and
tighten fi rmly.
6
3
•
Install bagger latch extension spring (7) as shown.
•
Repeat steps for left-hand bagger latch assembly.
TO INSTALL BAGGER FULL LEVER/EXTENSION
(See Fig. 17)
Before installation or adjusting, tractor engine must be shut
off and parking brake engaged.
• Remove center discharge chute. (See "To Remove
Center Chute" in section 6 of this manual.)
• Remove bolt (1) from chassis. Place cover (2) in slots
(3) in backplate. While holding cover in place, place
lever (4) through slot and reinstall bolt (1). Adjust as
needed.
1
2
3
TO ADJUST BAGGER FULL LEVER/EXTENSION
(See Fig. 18)
Slide bagger full extension (3) to the desired position.
•
For the heaviest/wet grasses, slide bagger full exten-
sion (3) all the way in.
•
For the lightest/driest grasses, pull bagger full exten-
sion (3) all the way out.
ASSEMBLY
5
4
Fig. 15
7
Fig. 16
1
4
Fig. 17
TO INSTALL BAGGER PRESENCE LEVER
(See Fig. 18)
WARNING: Shut off tractor engine and engage
parking brake before installing the bagger
presence lever.
•
Position bagger presence lever (1) on backplate with
anti-rotation tab in slot on backplate and align with
mounting hole.
•
Attach bagger presence lever to the backplate using
screw (3) and nut (2) and tighten fi rmly.
TO INSTALL TOW HITCH (See Fig. 19)
•
Remove screws from tow hitch. Save for future use.
•
Slide tow hitch through slot in backplate as shown.
•
Align holes in tow hitch with the holes in the backplate.
Reinstall screws through backplate as shown. Tighten
securely.
SCREWS
SLOT
BACKPLATE
9
3
2
1
Fig. 18
TOW HITCH
Fig. 19