Husqvarna TC 242TX Operator's Manual page 28

Hide thumbs Also See for TC 242TX:
Table of Contents

Advertisement

SERVICE AND ADJUSTMENTS
TO REMOVE CABLES, REVERSE ORDER -
BLACK cable fi rst from chassis and then from the fully
charged battery.
RED cable last from both batteries.
WEAK OR
DEAD BATTERY
BATTERY MAINTENANCE (See Figs. 51 - 53)
WARNING: Not following instructions can
result in sparks, arcing, or open fl ames which
could lead to serious personal injury, or prop-
erty damage. Before handling battery (1),
re move metal brace lets, wrist watch bands,
rings, etc. from your person. Touch ing these
items to battery could result in burns.
WARNING: Ensure tractor ignition switch
is in the OFF position and ignition key is
REMOVED.
1. Battery
2. Ground screw (Silver)
3. Protective sleeve
4. Terminal end
5. RED Battery Cable (+)
6. Solenoid stud
7. Battery door latch
(Shown in closed position)
8. Battery door
5
3
4
2
FULLY CHARGED
BATTERY
Fig. 50
9. Battery door holders
10. Square nut
11. Bolt
12. BLACK Battery
Cable (-)
13. Battery terminal
14. Red terminal boot
15. Bagger Support
Bracket
12
Fig. 51
7
15
11
13
10
REMOVAL
Locate silver ground screw (2) on right side plate of
tractor, above right rear tire.
Using a ½ inch (13mm) wrench or socket, completely
remove the silver ground screw (2) and set aside.
Pull protective sleeve (3) over exposed terminal end
(4) COMPLETELY covering terminal end.
Using a 7/16 inch (11mm) wrench or socket, remove
larger RED (+) battery cable (5) from solenoid stud (6).
DO NOT REMOVE smaller red wire from wiring har-
ness on solenoid stud.
From the rear of the tractor, open battery door (8) and
6
let it rest on the right hand bagger support bracket (15).
WARNING: Before pulling battery out of the
battery compartment, ensure the red terminal
boot (14) is covering the positive terminal (+).
Pull battery (1) with both cables attached out of battery
compartment and rest on battery door (8).
MAINTENANCE
Slide red teminal boot (14) up positive cable (+) to
expose the positive terminal (+).
Remove square nuts (10), bolts (11) and battery cables.
Clean / remove / replace battery (1) as needed.
28
12
8
Fig. 52
11
12
Fig. 53
9
5
14
1
14
5
13
10

Advertisement

Table of Contents
loading

Table of Contents