Service And Adjustments - Husqvarna TC 242TX Operator's Manual

Hide thumbs Also See for TC 242TX:
Table of Contents

Advertisement

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS:
Depress brake pedal fully and set parking brake.
Place attachment clutch in "DISENGAGED" position.
Turn ignition key to "STOP" and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TO REMOVE CENTER CHUTE (See Fig. 40)
1
2
I
J
K
Fig. 40
H
D
TO REMOVE MOWER (Fig. 41)
Remove center chute as described previously.
Place attachment clutch in "DISENGAGED" position.
Lower attachment lift lever to its lowest position.
Remove cable (I) by depressing tabs (J) and removing
cable end from bracket (K).
Remove mandrel cover (Q)
Remove mower belt from clutch pulley (M).
Dismantle the retainer spring (E) and remove the lever.
Dismantle the retainer spring (A) and remove the lever.
Dismantle the retainer spring (D) and remove the lever.
Remove retainer spring (F) and washer (G) from anti-
sway bar (H).
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.
Slide mower out from under right side of tractor.
TO INSTALL MOWER
Push in the mower deck under the tractor.
Assemble in the reverse order to dismantling.
M
A
E
F
G
Fig. 41
24
CAUTION: Attachment lift lever is spring
loaded. Have a tight grip on rod and re-
lease slowly.
A
Q

Advertisement

Table of Contents
loading

Table of Contents