Table of Contents
Advertisement
•
Connect the strut (6) to the left and right mid brackets
using two carriage bolts (7) on each side. Do not install
nuts in this step.
•
Install the right bagger pivot (8) using one screw (9)
and nuts (10) as shown. Repeat on opposite side.
10
TO ADJUST BAGGER (See Figs. 11 - 13)
HORIZONTAL ADJUSTMENT
The tractor comes from the factory with the bagger assem-
bly preset in a fi xed position. If necessary, this position
can be adjusted to maintain a consistent gap (A) between
the fender and the bagger assembly top. An ideal gap is
approximately 0.25" (6 mm).
•
Insert 1/2" (13mm) wrench under bagger assembly top
(1). Do NOT remove; ONLY loosen adjustment bolt
(2). Repeat on opposite side.
2
•
Slide bagger assembly into proper position.
•
Once bagger assembly is in proper position, tighten
adjustment bolts (2) on both sides to 100 In-Lbs/11,2
Nm. Do NOT overtighten.
•
Readjust if necessary.
ASSEMBLY
6
7
Fig. 9
8
Fig. 10
1
1
Fig. 11
VERTICAL ADJUSTMENT
If necessary, the vertical position of the bagger assembly
can be adjusted to maintain proper alignment (B) between
the fender and the bagger assembly top.
7
•
Remove bagger assembly.
•
Do NOT remove; ONLY loosen nuts (3).
•
Raise or lower the bagger support brackets (4) to proper
position and retighten nuts (3).
4
9
•
Replace bagger assembly onto bagger supports (4).
•
Readjust if necessary.
TO INSTALL BAGGER LATCH ASSEMBLY
(See Figs. 14 - 16)
WARNING: Shut off tractor engine and engage
parking brake before installing the bagger
latch assemblies.
•
Remove two screws (1) on right-hand bagger latch
assembly (2).
Left-Hand Bagger
Latch Assembly
•
Install right-hand bagger latch assembly (3) through
opening in backplate (4).
•
Position right-hand bagger latch assembly on backplate
with tab (5) in the slot on backplate and align with
mounting hole.
8
Fig. 12
3
Fig. 13
Right-Hand Bagger
Latch Assembly
2
1
Fig. 14
Advertisement
Table of Contents
