Checking The Output Power - Agilent Technologies E8257C Installation Manual

Operation Verification

Checking the Output Power

Checking the Output Power
This test verifies the CW output power from the signal generator. If this test fails, refer to
Output Power" on page 25
Table 3-2 shows the preferred equipment for use with the signal generator when performing this test.
Table 3-2
E8247C E8247C
E8257C E8257C
E8267C
Option Option
520 540
22
for further instructions.
Recommended Equipment
Test Equipment
Power Meter
Power Sensor,
Input: Type-N (m)
Power Sensor,
Input: APC 3.5 (m)
Power Sensor,
Input: 2.4 mm (m)
Adapter,
2.4 mm (f) to Type-N (f)
Adapter,
2.4 mm (f) to (f)
Adapter,
APC 3.5 (f) to (f)
Adapter,
APC 3.5 (f) to Type-N
(m)
Test Equipment
Agilent E4418B E-Series power meter
or Agilent E4419A/B E-Series power meter
Agilent E9304A E-Series power sensor
or Agilent 8482A power sensor
Agilent E4413A E-Series power sensor
Agilent 8487A Option H84 power sensor
Option H84 adds a Standards Lab Calibration
Agilent 11903B
2.4 mm (f) to Type-N (f) adapter
Agilent 11900B
2.4 mm (f) to (f) adapter
Agilent 1250-1749
APC 3.5 (f) to (f) adapter
Agilent 1250-1744
APC 3.5 (f) to Type-N (m) adapter
"Problems with
Chapter 3