Table of Contents
Advertisement
Installation
Power Cable for Charger Input
Power Cable for Charger Input
The 85901A is equipped with a three-connector power cable.When
connected to an appropriate ac power receptacle, this cable grounds the
instrument cabinet.
The mains plug may only be inserted in a socket outlet
WARNING
provided with a protective earth contact. The protective action
must not be negated by the use of an extension cord (power
cable) without a protective conductor (grounding). Grounding
one conductor of a two-conductor outlet is not sufficient
protection. Various power cables are available to connect the
instrument to the types of ac power outlets unique to specific
geographic areas. The cable appropriate for the area to which
the analyzer is originally shipped is included with the unit.
While the inverter output is used, the 85901A will meet its EMI
NOTE
specification with the charger input power cable removed.
Power Cable for Inverter Output
The 85901A standard connector is two CEE22-V connectors in place of
the USA standard NEMA-15P connector. The interconnection cable,
Part Number 8120-5220, CEE22-V male to NEMA-15P female, is
provided. This cable is used to connect external instruments to the
inverter output.
Other general-purpose power-cord adapters are available. The adapters
listed below allow country-specific line cords to be plugged into the
85901A AC Power Source.
Europe
U.S.A.
United Kingdom
2-10
HP/Agilent Part Number 8120-5210
HP/Agilent Part Number 8120-5211
HP/Agilent Part Number 8120-5212
Chapter 2
Advertisement
Table of Contents
