Unloading At The End Of A Cycle - Baumatic BDW1W/SS Instruction Manual

WHAT YOU WILL SEE ON THE DISPLAY:
A FORGOTTEN DISH CAN BE ADDED AT ANY TIME BEFORE THE DETERGENT DISPENSER OPENS.
OPEN THE DOOR A LITTLE TO STOP THE WASHING.
•
AFTER THE SPRAY ARMS STOP WORKING, YOU CAN OPEN THE DOOR COMPLETELY.
•
ADD FORGOTTEN DISHES.
•
CLOSE THE DOOR, THE DISHWASHER WILL WORK AFTER TEN SECONDS.
•
At end of washing, the time display will flash for 8 seconds while the ALARM
however. CAUTION – HOT interior. Leave about ½ hour before unloading.
BAUMATIC BDW1W/SS dishwasher user manual
FORGET TO ADD A DISH?
Need to Change the Cycle?
1. PRESS THE POWER SWITCH TO STOP WASHING
2. PRESS THE 'PROG.' BUTTON TO SELECT THE NEW PROGRAM
3. PRESS THE POWER SWITCH AGAIN TO START WASHING
* Note – You may have to start a new cycle by reloading the detergent if it has
been a long time since the old cycle began. See page 12 to see how to do this.
At the End of the Wash Cycle
sounds. The ALARM will not sound at the end of delayed washing,
SHOWS THE SELECTED WASHING
PROGRAM (From Left): INTENSIVE, NORMAL,
ECONOMY, RINSE, GLASS, RAPID, PRE-RINSE.
INFORMATION DISPLAY: YOU CAN GET
INFORMATION FROM READING WHAT IS SHOWN
ON THIS, SUCH AS WASHING PROGRAM, ERROR,
DOOR-OPEN, ETC.
WASHING PHASE: (From left) The first sign is
Pre-rinse; the second sign is main wash; the third
sign is rinse; the fourth sign is drying. They will
run and alternate during washing.
STATE INFORMATION: (From top) The first
sign shows the time remaining in a washing
program. The middle sign indicates the delay time
involved. The bottom sign shows the display of the
temperature.
DIGITAL DISPLAY: Shows the remaining time,
error codes and the delay time.
CHOICE OF TEMPERATURE: YOU CAN CHOOSE
A WASH FROM FOUR AVAILABLE TEMPERATURES.
THE INTENSITY OF WASHING WILL BE CHANGED.
14
14