Change The Programme; At The End Of The Wash Cycle - Baumatic BDW603SS1 User Manual

60cm freestanding dishwasher
Table of Contents

Advertisement

NO T E :
When you press the Start/Pause button to pause during washing,
stop blinking and the buzzer
button to start.
Change the Program
Premise:
1
A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the section entitled " Loading the
Detergent " ).
2
Press the Start/Pause button , the machine will pause, press the program button more than 3s then you
can change the program to the desired cycle setting (see the section entitled " Starting a wash cycle. . ." ).
NOTE:
If you open the door
s top blinking and the buzzer
you clos e the door , the machine will keep on working after 10 s econds .
If your model has b roken remember function, the machine will go on to finis h the s elected
program after the power cut.
Forgot to Add a Dish
A forgotten dish can be added any time before the detergent cup opens.
1
Press the Start/Pause Button to stop the washing.
2
Open the door a little .
3
After the spray arms stop working, you can open the door
completely.

At the End of the Wash Cycle

When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the program has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap.
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
NOTE:
Wash the arms in soapy and warm water and use a soft brush to
WARNING!
clean the jets. Replace them after rinsing them thoroughly.
will be sound
during a was h cycle
It is dangerous to open the door when washing, because the hot water may scald you.
every minute unless
, t he machine will paus e. T he program light will
will be s ound
e very minute unles s y ou clos e the door . After
4
Add forgotten dishes.
5
Close the door
6
Press the Start/Pause Button, the dishwasher will run
after 10 seconds.
9
The program light will
you press the Start/Pause

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bdw603w1

Table of Contents