Table of Contents
Advertisement
How to Set the Post-Receiver Off-Hook (ROH) Option
Use the following key sequence to set the post-ROH option:
Press:
The < > brackets represent the 1-digit post-ROH option:
enter:
enter:
You must enter either 0 or 1, otherwise the FWT will not update or store
this value and the existing stored parameter will remain. The factory defualt
setting is 1.
How to Set the Pulse Dial Option
Use the following key sequence to set the Pulse Dial option:
Press:
The < > brackets represent the 1-digit Pulse Dial option:
enter:
enter:
You must enter either 0 or 1, otherwise the FWT will not update or store this
value; the existing factory default setting is 1.
How to Initiate a Ring-Back Request
Use the following key sequence to initiate an immediate Ring Back:
Press:
There is no Ring Back value to be entered; the command activates
when the phone is placed on-hook.
How to Restore the Factory Default Settings
Use the following key sequence to restore the factory default settings:
Press:
There is no Restore Defaults value to be entered; the command acti-
vates immediately. If you enter a value, it will be invalid and the FWT will not
restore the factory defaults. Note: NAM (Phone Number Setup) data is not
affected by this command and will not be changed.
RAYCOM C
(AMPS)
ELLULAR
AMPS TECHNICAL PROGRAMMING COMMANDS
# * 9 * <Post-ROH option> #
0 for continuous ROH tone
1 to turn off ROH tone and periodically check for an
on-hook condition.
# * 12 * <Pulse Dial option> #
0 to disable pulse dialing capability
1 to enable pulse dialing capability.
# * 13 * #
# * 15 * #
29
Advertisement
Table of Contents
