Table of Contents
Advertisement
Step #6 - How to Override the Number of Dedicated Control Channels
Press:
The spaces represent your 2-digit range of Dedicated Control Channels. When
you first turn on the Raycom, it automatically scans up to 21 control channels
looking for your cellular provider. Then, it locks onto the strongest signal.
NOTE: the factory default setting is 21 channels. To change the number of
channels, you must enter a 2-digit value in the range of 01 to 21. (For
instance, to set up 9 control channels, enter: #*26*09#.) If you enter the
range incorrectly, you'll hear three short tones followed by the programming
tone; if correct, you'll hear the programming tone again.
Step #7 - How to Override the System Preference.
Press:
The space represents your 1-digit system preference.
This sets the preference for your cellular provider. If you enter the
preference incorrectly, you'll hear three short tones followed by the
programming tone; if correct, you'll hear the programming tone again.
Step #8 - Hang up. The flashing LED indicator will become solid GREEN.
Phone number setup is complete.
Optional A-Key (Authentication Code) Programming
Depending upon your cellular service provider, you may be required to enter
an Authentication Code (A-Key) before you make or receive any calls. Contact
your service provider to determine whether A-Key is required.
!
RAYCOM C
RAYCOM C
(AMPS)
(AMPS)
ELLULAR
ELLULAR
# * 26 * _ _ #
# * 7 * _ #
enter:
0 for System "A" preferred
enter:
1 for System "B" preferred
enter:
2 for System "A" only
enter:
3 for System "B" only.
For security reasons, your complete A-Key is never transmitted over the
phone. However, you should keep the number in a safe place to prevent
counterfeiting, fraud or cloning.
STEP 3. PHONE NUMBER SETUP
IMPORTANT!
12
12
Advertisement
Table of Contents
