Table of Contents
Advertisement
How to Set the Access Overload Class (ACCOLC)
Use the following key sequence to set the ACCOLC:
Press:
The < > brackets represent the 2-digit ACCOLC. You must enter a
2-digit value between 00 and 15, otherwise the FWT will not update
or store this value; the existing stored parameter will remain. (For example, to
program the FWT for ACCOLC 8, enter: # * 2 * 08 #.)
How to Set the Access Method (EX) Option
Use the following key sequence to set the EX option:
Press:
The < > brackets represent the 1-digit EX option:
enter:
Identification Number) when accessing the system
enter:
You must enter either 0 or 1, otherwise the FWT will not update or store this
value; the existing stored parameter will remain. The factory default setting is 1.
How to Set the Roam Option
Use the following key sequence to set the Roam option:
Press:
The < > brackets represent the 1-digit Roam option:
enter:
enter:
You must enter either 0 or 1, otherwise the FWT will not update or store this
value; the existing stored parameter will remain. The factory default setting is 0.
How to Set the Dial Tone After Remote On-Hook Option
Use the following key sequence to set the Dial Tone After Remote
On-Hook option:
Press:
The < > brackets represent the 1-digit dial tone option:
enter:
enter:
You must enter either 0 or 1, otherwise the FWT will not update or store this
value; the existing stored parameter will remain. The factory default setting is 1.
RAYCOM C
(AMPS)
ELLULAR
AMPS TECHNICAL PROGRAMMING COMMANDS
# * 2 * < ACCOLC > #
# * 3 * <EX option> #
1 if the FWT must always send the full MIN (Mobile
0 if not.
# * 6 * <Roam option> #
0 to enable roaming
1 to disable roaming.
# * 8 * <Dial Tone option> #
0 for no dial tone after a remote on-hook
1 to enable dial tone after remote on-hook.
28
Advertisement
Table of Contents
