Something Not Working; Troubleshooting - AEG LAVAMAT L 60600 Instruction Booklet

Important
! !
Every time you drain the water through the emergency emptying hose
you must pour 2 litres of water into the main wash compartment of the
detergent drawer and then run the drain programme "C". This will acti-
vate the ECO valve avoiding that part of the detergent remains unused
at next washing.

Something not working?

If during the spin cycle the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a
new type of motor.
If water is not visible in the drum, this is due
to the modern technology of new washing
machines that use less water than traditional
machines.

Troubleshooting

If a problem arises, you can try to solve it yourself following the
instructions below.
If you call out an engineer when one of the following problems arises,
or to repair a fault due to incorrect use, the call-out will be charged
even if requested within the guarantee period.
During machine operation the following alarm codes may be displayed:
- E10: problem with the water supply (phase light
- E20: problem with water draining (phase light
- E40: door open (phase light
Once the problem has been eliminated, press the START/PAUSE button
to restart the programme. If after all checks, the problem persists, con-
tact your local AEG Service Force Centre.
Problem
The machine does not work
is on)
Possible cause
The main electrical fuse
has blown.
The door is not properly
closed (E40).
The plug is not connected. Insert the plug.
The START button has not
been pressed.
The DELAY START
option has been selected.
Something not working?
is on)
is on)
Solution
Replace the fuse.
Close the door; the click
of the lock should be heard.
Press the button.
Check the selected delay on
the display.
77