Emergency Emptying Out; Frost Precautions; Something Not Working; Troubleshooting - AEG ÖKO-LAVAMAT 1051 VI Instruction Booklet

Cleaning and maintenance

Emergency emptying out

If the water is not discharged (pump is blocked, filter or drain hose are
clogged), proceed as follows to empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled;
• place a bowl on the floor;
• put the drain hose end into the bowl and let the water come out.
Should it not be possible to have access to the drain hose because, for
example the appliance is built in the kitchen furniture, slightly loosen
the drain filter after placing a bowl on the floor to let the water come
out slowly.
At the end screw the filter again.

Frost precautions

If the machine is installed in a place where the temperature could drop
below 0°C, proceed as follows:
• Close the water tap and unscrew the water inlet hose from the tap.
• Place the end of the drain hose and the inlet hose in a bowl placed
on the floor.
• Select the "drain" programme D and run it until the machine stops.
• Turn the programme selector dial to RESET O.
• Press the ON/OFF button
• Remove the plug from the power socket.
• Screw the water inlet hose back on and put the drain hose back in its
place.
By doing this, any water remaining in the machine is removed, avoid-
ing the formation of ice and, consequently, breakage of the parts
involved.
When you use the machine again, make sure that the ambient temper-
ature is above 0°C.
162
to switch the machine off.

Something not working?

If, during the spin cycle, the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a new type of
motor.
If water is not visible in the drum, this is due to
the modern technology of new washing
machines that use less water than traditional
machines.

Troubleshooting

If a problem arises, you can try to solve it yourself following the
instructions below. If you call out an engineer when one of the follow-
ing problems arises, or to repair a fault due to incorrect use, the call-
out will be charged even if requested within the guarantee period.
During machine operation the following alarm codes may be displayed:
- E00: problem with the water supply
- E10: problem with water draining
- E20: door open
Once the problem has been eliminated, press the START/PAUSE button
to restart the programme. If after all checks, the problem persists, contact
your local AEG Service Force Centre.
Problem
The ON/OFF button
has not been depressed.
The main electrical fuse
has blown.
The door is not properly
closed (E20).
The machine does not work
The plug is not connected. Insert the plug.
The START button has not
been pressed.
The DELAY START
option has been selected.
Possible cause Solution
Depress the button.
Replace the fuse.
Close the door; the click
of the lock should be heard.
Press the button.
Check the selected delay on
the display.
163