Raymarine Autohelm ST7000 Installation Instructions Manual page 29

Mercruiser Installation
(Using DI 37 Kit) (Also OMC &Yamaha)
The drive unit should be mounted onto the tiller
end block and the pushrod connected to the cable
end sheath via a custom mounting bracket. The
first stage of installation is to fit the custom
bracket:-
Mercruiser Bracket Mounting Kit (D137)
24
Installation
• Remove locating pin attaching cable rod to
tiller end block and slide the drive unit 'C'
bracket over the end block.
• Secure by pushing the supplied clevis pin
upwards through the drive unit 'C' bracket,
end block and cable rod end.
• Secure the assembly by inserting the split pin
through the drive 'C' bracket (Fig.30).
• With the helm turned hard to port, assemble
the adaptor pin bracket and bracket clamp
onto the cable end sheath using the 2 socket
head bolts provided. This should be
positioned 165mm (6.5in) from the drive unit
'C' bracket clevis pin. Make sure the adaptor
pin bracket points upwards. (See Figs. 30, 31
& 32).
• Position the drive unit pushrod over the top of
the adaptor pin and secure with the spring clip
(Figs. 30 & 32).
Slowly turn the steering system from hard over to
hard over. It is most important that the drive
unit and the adaptor pin bracket do not touch
any part of the engine or steering system.