Raymarine maxiview operation and setup st80 (71 pages)
Summary of Contents for Raymarine ST7001+
Page 1
Distributed by Any reference to Raytheon or RTN in this manual should be interpreted as Raymarine. The names Raytheon and RTN are owned by the Raytheon Company.
ST7001+ Control Unit Quick Reference Guide Basic operation Auto mode Entering Auto mode Returning to Standby (Engaging the autopilot) (Disengaging the autopilot) Making course changes 1˚ Course changes to port 10˚ Returning to previous locked heading then Using AutoTack AutoTack to port Adjusting response level To make temporary changes:...
Compass calibration Enter Seatrial Calibration 2 sec Compass deviation correction Turn boat in slow circles so: • boat's speed stays below 2 knots • each circle takes at least 2 minutes Minimum of 2 circles Compass heading alignment Coarse adjustment: If COG is available from GPS, press Fine adjustment: If COG is not available (or after setting heading to COG), align autopilot heading manually: Adjust the autopilot heading so it shows the same value as the boat's steering compass...