Rangemaster Toledo 90 Electric User Manual page 26

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
LH oven
Pull cooker forward to gain access to the
cover box at the rear of the cooker. Remove
the screws securing the cover and lift clear.
Feed the thermostat capillary out of the oven.
Disconnect wiring from thermostat. Remove 2 screws
holding thermostat to mounting panel. Fit new
thermostat and reassemble in reverse order. Ensure
that the phial is clipped to the oven back with the phial
centrally positioned between the clips.
Check operation of thermostat.
8. To Change Grill Controller
Lift up the ceramic hob top (see 2). Remove control
panel (see 4). Disconnect wiring from controller.
Remove 2 screws holding controller to mounting panel.
Fit new controller and reassemble in reverse order.
Check for correct operation.
9. To Remove Grill Door
Remove the left hand side panel (see 1). Remove the
control panel (see 4). Remove the centre cover strip
(5 screws, 2 top, 2 bottom, 1 in middle). Remove the
two countersunk screws (1 each side) securing the grill
hinge arms to the front of the grill chamber.
NOTE: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket
is fi tted between the hinge arm and the front of the grill
chamber.
10. To Remove Main Oven Door
Open oven door and remove Handyrack (where fi tted)
by springing one side out of the bracket on the door and
sliding the other side free. Support the door and remove
the two screws securing the upper hinge and packing to
the cooker front. Remove the door from the lower hinge
by lifting slightly and moving outwards.
Reassemble in reverse order.
11. To Change Main Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fi xing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2
retaining nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
12. To Change Main Oven Door Latch
Remove outer door panel (see 15). Remove screws
'B' holding latch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
13. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal diagonally
away from the door centre until that hook is released.
Proceed to the next hook and release it in a similar way,
and so on. Use force if the hooks are stiff, as the old
seal will be discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door snapping in each
hook in turn.
14. To Adjust Main Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fi t is
obtained. Retighten locking nut.
26