Simple Wired Remote Conrol (Rch-E3) - Mitsubishi Heavy Industries SRK100VNXPZSX Technical Manual

(1) SIMPLE WIRED REMOTE CONTROL (RCH-E3)
Names and functions of sections
Operation/Inspection lamp
During operation: Green
failure: Red
MODE button
Use to select the mode.
TEMP button
Use to raise the setting temperature.
TEMP button
Use to lower the setting temperature.
Operation mode display
: Cooling
: Drying
: Fan operation
: Heating
: Auto mode
Central control display
Displayed when controlling the
unit with the central control.
Control disable display
The lamp is lit for 3 seconds
when a disabled button is
pressed.
Installation of remote control
Do not install the remote control at the following places in order to avoid malfunction.
(1) Places exposed to direct sunlight
(2) Places near heat devices
(3) High humidity places
Indoor unit No. display
(4) Hot surface or cold surface enough to generate condensation
(5) Places exposed to oil mist or steam directly
(6) Uneven surface
192
- -
'17 • PAC-T-257
Remote control sensor
ON/OFF button
Button to start/stop the air - conditioner
FAN SPEED button
Button to set the fan speed
AIR CON No. button
Indicates the No. of air - conditioner
which is connected.
VRF series outdoor unit No. display
Fan speed display
Ventilation display
This is lit during the ventilation
operation.
Setting TEMP display
Error code display
PJZ000Z272
Remo
Wiring o
(In case of embe
12×7 slo
In ca
0.3mm
L
Wirin
(1)
(2)