Filter Sign; Outline Of Automatic Operation - Mitsubishi Heavy Industries SRK100VNXPZSX Technical Manual

Table of Contents

(c)

In case of anomaly

If any anomaly occurs on a unit in a group (a protective function operates), that unit stops with the anomalous

stop but any other normal units continue to run as they are.

Signal wiring procedure

Signal wiring between indoor and outdoor units should be made on each unit same as the normal wiring. For

the group control, lay connect with sires wiring between rooms using terminal blocks (X, Y) of interface kit.

Connect the remote control communication wire separately from the power supply wire or wires of other

electric devices (AC220V or higher).

(10) Filter sign

As the operation time (Total ON time of ON/OFF switch) accumulates to 180 hours (1), "Filter cleaning" is displayed on the

remote control. (This is displayed when the unit is in trouble and under the centralized control, regardless of ON/OFF)

Note (1) Time setting for the filter sign can be made as shown below using the indoor function of wired remote control "FILTER SIGN SET". (It is set at 1 at the

shipping from factory.)

Filter sign setting

Setting 1

Setting 2

Setting 3

Setting 4

(2) After the setting time has elapsed, the "FILTER CLEANING" is displayed and, after operating for 24 hours further (counted also during the stop), the unit

stops.