Table of Contents
Advertisement
INSTRUCTIONS FOR USE
SHAVING
1.
Switch the shaver on by pressing the on/off button.
2.
Stretch the skin with your free hand so the hairs stand upright.
3.
Only apply light pressure on the shaving head while shaving (pressing too hard can
cause skin irritation).
4.
Use short, circular strokes.
SHAVING WITH SHAVING GEL
•
Follow the same instructions as dry shaving if using shaving gel.
•
CAUTION After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.
TURBO FEATURE
Use the Turbo feature to shave thick stubble. Press the turbo button to operate the
shaver in Turbo mode. The turbo button will light up white. Press the turbo button again
to deactivate turbo mode.
DETAIL TRIMMER AND COMB ATTACHMENT
To fit the detail trimmer and comb attachment:
1.
Switch off your shaver.
2.
Grasp the head and cutter assembly and pull it away from the body of your shaver
(Fig A).
3.
If using, clip the adjustable comb over the trimming attachment (Fig. B)
4.
Clip the detail trimmer onto the body of your shaver (Fig. C).
TRAVEL LOCK
The travel lock feature prevents the shaver from turning on and discharging accidentally
while stored away or travelling. To lock, press and hold the turbo button for 3 seconds
until the Licon comes on. To unlock, press and hold the turbo button for 3 seconds until
the Licon switches off.
TIPS FOR BEST RESULTS
•
Always hold the shaver at right angles to the skin so that all three heads are
touching the skin with equal pressure.
•
Use moderate to slow stroking movements. The use of short circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
•
DO NOT press hard against the skin in order to avoid skin irritation.
6
Advertisement
Table of Contents
