Table of Contents
Advertisement
SHAVING WITH SHAVING GEL
•
Follow the same instructions as dry shaving if using shaving gel.
•
CAUTION After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.
DETAIL TRIMMER ATTACHMENT
To fit the detail trimmer attachment:
1.
Switch off your shaver.
2.
Pull the head and cutter assembly away from the body of your shaver (Fig A).
3.
Clip the detail trimmer onto the body of your shaver (Fig. B).
TIPS FOR BEST RESULTS
•
Always hold the shaver at right angles to the skin so that all three heads are
touching the skin with equal pressure.
•
Use moderate to slow stroking movements. The use of short circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
•
DO NOT press hard against the skin in order to avoid skin irritation.
CARE FOR YOUR SHAVER
Care for your shaver to ensure a long lasting performance. We recommend you clean
your shaver after each use.
•
Ensure your shaver is switched off before cleaning.
1.
Open the shaver head by pressing the release button (Fig. C).
2.
The head assembly will open (Fig. D).
3.
Rinse under a tap to wash away hair trimmings.
4.
Carefully brush away any hairs from the cutters.
5.
Close the head assembly.
Note: The individual cutters are designed to be permanently retained in the shave head
and flushed out with water. Do not remove the individual cutters for cleaning.
DETAIL TRIMMER
Lubricate the teeth of the detail trimmer every six months with a drop of sewing machine
oil.
6
Advertisement
Table of Contents
