Remote Control; General - Insignia NS-32D220MX18 User Manual

Problem Solution
Poor picture.
• Make sure that the room is not
• If an S-VHS camera or a
Good sound, but
• Adjust the contrast, color, and
poor color.
Audio noise.
• Other devices (for example, a
No output from
• Adjust the audio balance. See
one of the
speakers.
• Test the TV's speakers. See
After images
• Do not display a still image,
appear.
too bright. Light reflecting off
the screen can make the picture
difficult to see.
camcorder is connected while
another connected device is
turned on, the picture may be
poor. Turn off one or more
devices.
brightness settings. See
Adjusting the TV picture on
page 46.
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
Adjusting sound settings on
page 48.
Testing the TV speakers on
page 67. If one or both of the
speakers fails, try one of the
following solutions:
• Make sure that the audio
cables are connected
correctly and securely to your
TV.
• Make sure that the audio
cables are connected to the
AUDIO OUT jacks on the
connected device.
• Try a different set of audio
cables.
• Make sure that the sound on
the connected device is not
muted.
• Try connecting the device to
a different TV. If you do not
hear sound, the problem is
with the device.
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
www.insigniaproducts.com

Remote control

Problem Solution
Remote
• Make sure that the power cord is
control does
plugged into a working outlet.
not work.
• Make sure that there are no
obstructions between the remote
control and the remote control sensor
on the front of the TV.
• Point the remote control directly at
the remote control sensor on your TV.
See
page 33.
• The supplied batteries are wrapped
tightly in clear plastic. Make sure that
you have removed this plastic from
the batteries.
• Make sure that the batteries are
installed correctly. See
remote control batteries
• Replace dead batteries with new
batteries. See
control batteries
Trouble
• See instructions in
programming
universal remote controls
your existing
• Codes are subject to change. For
universal
up-to-date codes, go to
remote
Viewing universal remote control
control.
codes
www.insigniaproducts.com/remotecodes
• Replace dead batteries with new
batteries.
• Refer to the User Guide that
accompanied your universal remote
control and contact the manufacturer
if problems persist.

General

Problem Solution
No power.
• Make sure that the power cord is
plugged into a working outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord back in
and turn on your TV.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may be
interfering with your TV. Try turning
off one device at a time to determine
which device is causing interference.
After you have determined which
device is causing interference, move it
further from the TV to eliminate the
interference.
"No signal"
• Press INPUT and make sure that you
error message
have selected the correct input for the
is displayed.
device or service you are trying to use.
• If you are using a cable or satellite
box, use the remote that came with
that box to change channels.
32" 720p/43" 1080p 60Hz LED TV
Aiming the remote control
Installing
on page 33.
Installing remote
on page 33.
Programming
on page 34.
on page 34 or visit
on
71