Table of Contents
Advertisement
Redial
The redial/p key redials the last number dialed. The redialed number can be up
to 32 digits long.
Tone Dialing Switch-over
Some telephone companies use equipment that require pulse
dialing (sometimes referred to as rotary dialing). If you
need to enter tone dialing digits, you can switch-over to
tone dialing during the call. An example of this could be
entering your bank account number after you have called your bank. The digits of
your bank account can be sent using DTMF tones.
Initially make your call with the pulse dialing mode. Once your call connects,
press */tone
. Enter the desired number (like in example above the bank
account number). These digits will be sent as tone dialing. This special number
can be stored in a memory location. This is referred to as Chain Dialing (See page
24.) Once the call ends, the tone mode is canceled and pulse dialing
mode resumes.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit,
noise increases. If you pass the range limits of the base unit, your call will
terminate within 30 seconds.
The tone feature only
applies when the dial
mode is set to pulse.
B A S I C S
[ 17 ]
Advertisement
Table of Contents
