Table of Contents
Advertisement
132
STARTING AND OPERATING
Rear Cross Path View
Pressing the Rear Cross Path View button
will give the driver a wider angle view of the
rear camera system.
Front View Plus Top View
Pressing the Front Plus Top View button will
show you what is immediately in front of the
vehicle and is always paired with the Top
View of the vehicle.
Front Cross Path View
Pressing the Front Cross Path View button
will give the driver a wider angle view of the
front camera system. The Top View will be
disabled when this is selected.
NOTE:
If the Rear View Camera view was selected through the
Surround View Camera menu, exiting out of the Rear
View screen will return to the last known Surround View
screen. If the Back Up Camera was manually activated
through the Controls menu of the Uconnect system,
exiting out of the display screen will return to the Con-
trols menu.
Deactivation
The system can be deactivated under the following
conditions:
•
The speed of the vehicle is greater than 8 mph
(13 km/h).
•
The vehicle is shifted into PARK.
•
The vehicle is in any gear other than REVERSE and
the touchscreen X button is pressed.
•
The camera delay system is turned off manually
through the Uconnect Settings menu
NOTE:
•
If snow, ice, mud, or any foreign substance builds up
on the camera lenses, clean the lenses, rinse with
water, and dry with a soft cloth. Do not cover the
lenses.
•
If a malfunction with the system has occurred, see
an authorized dealer.
Drivers must be careful when backing up even when
using the Surround View Camera. Always check care-
fully behind your vehicle, and be sure to check for
pedestrians, animals, other vehicles, obstructions, or
blind spots before backing up. You are responsible for
the safety of your surroundings and must continue to
pay attention while backing up. Failure to do so can
result in serious injury or death.
•
To avoid vehicle damage, Surround View should
only be used as a parking aid. The Surround View
camera is unable to view every obstacle or object
in your drive path.
•
To avoid vehicle damage, the vehicle must be
driven slowly when using Surround View to be able
to stop in time when an obstacle is seen. It is rec-
ommended that the driver look frequently over
his/her shoulder when using Surround View.
page 142.
WARNING!
CAUTION!
REFUELING THE VEHICLE — GAS
1. Ensure that the vehicle doors are unlocked as this
unlocks the fuel door.
2. Open the fuel filler door by pushing on the outer
edge of the fuel door.
Fuel Filler Door
NOTE:
There is no fuel filler cap. Two flapper doors inside
the pipe seal the system.
3. Insert the fuel nozzle fully into the filler pipe; the nozzle
opens and holds the flapper door while refueling.
Advertisement
Table of Contents
