Table of Contents
Advertisement
Charge Settings — If Equipped
The fifth screen within the Hybrid Electric App is the
Charge Setting screen. From this screen, you can select
the rate at which your vehicle charges. Rate selections
1 (low rate of charge) through 5 (high rate of charge)
are available. The lower the selected rate, the longer it
will take for your vehicle to reach a full charge.
Charge Setting Screen
The Charge Setting can be adjusted by pressing the "+"
or "-" buttons, and the estimated time until full charge
will update on the right side of the screen to reflect the
selected Charge Setting. The display also shows infor-
mation related to:
•
Battery Level — Indicates, in percentage, the high-
voltage battery SOC.
•
Estimate time to 100% — Corresponds to the time
required to obtain full recharging of the high-voltage
battery.
NOTE:
•
The Charge Setting will be saved each time the
vehicle is turned off, then back on again.
•
For information on jump starting your vehicle
page 205.
KEYS
KEY FOBS
Your vehicle is equipped with a key fob which supports
Passive Entry, Remote Keyless Entry (RKE), Keyless
Enter 'n Go™ (if equipped), Remote Start (if equipped),
and Panic button operation. The key fob allows you to
lock or unlock the doors and liftgate from distances up
to approximately 66 ft (20 m). In some conditions, this
distance can be reduced or increased. The key fob does
not need to be pointed at the vehicle to activate the
system. The key fob also contains an emergency key,
which is stored in the rear of the key fob.
NOTE:
•
The key fob's wireless signal may be blocked if the
key fob is located next to a metallic object, mobile
phone, laptop, wireless charging pad, or other elec-
tronic device. This may result in poor performance.
•
If the key fob's battery is near depletion, the key fob
performance can be reduced.
•
With the ignition on and the vehicle moving at
2 mph (4 km/h), all RKE commands are disabled.
GETTING TO KNOW YOUR VEHICLE
Keyless Ignition Key Fob
1 — Unlock
2 — Liftgate
3 — Panic
4 — Lock
5 — Remote Start (If Equipped)
NOTE:
In case the ignition switch does not change with the
push of a button, the key fob may have a low or fully
depleted battery. A low key fob battery can be verified
by referring to the instrument cluster, which will display
directions to follow
page 263.
31
2
Advertisement
Table of Contents
