Toshiba CL10W User Manual page 32

A recovery image of the software on your computer is stored on the internal
storage, and can be copied to either disc media or USB Flash Memory by
using the following steps:
1.
2.
3.
4.
5.
Restoring the pre-installed software from your created
Recovery Media
If the pre-installed files are damaged, you are able to use the Recovery
Media you have created to restore the computer to the state it was in when
you originally received it. To perform this restoration, do the following:
1.
User's Manual
Do not use utilities, including those intended to enhance internal
storage access speed. They might cause unstable operation and
damage data.
Do not shut down/log off or Sleep/Hibernate while writing or rewriting
the media.
Set the computer on a level surface and avoid places subjected to
vibrations such as airplanes, trains, or cars.
Do not use on an unstable surface such as a stand.
Select either blank disc or USB Flash Memory.
Some of the disc media might not be compatible with the optical disc
drive connected to your computer. You should therefore verify that the
optical disc drive supports the blank media you have chosen before
proceeding.
USB Flash Memory will be formatted and all the data in the USB Flash
Memory will be lost when proceeding.
Turn on your computer and allow it to load the Windows operating
system as normal.
Insert the first blank disc into the optical disc drive tray, or insert the
USB Flash Memory into one available USB port.
Click Control Panel -> System and Security -> Security and
Maintenance -> Recovery -> Create a recovery drive under
Windows System group in All apps.
Follow the on-screen instructions to finish creating the Recovery
Media.
When you reinstall the Windows operating system, internal storage will
be reformatted and all data will be lost.
Make sure to use the default Boot Mode option in TOSHIBA Setup
Utility before restoring.
Launch the TOSHIBA Setup Utility.
Refer to the TOSHIBA Setup Utility section for further information.
2-16