Using Direct Entry; How To Use The Remote After You've Programmed It - RCA RW2110 Owner's Manual

8 7 Using the remote control
The remote control is
searching the first set of
component codes
(there are several sets of
codes). If the component you
want to operate doesn't turn
off automatically after 5 seconds, press
flashing again as the remote control searches through the next set of
codes).
Continue pressing
Note: If the component doesn't turn off after you've pressed the
button 20 times, the remote control can't be programmed to work
with that component.
4 Press
component turns back on.
5 To finish, press and hold the
remote control turns off.

Using Direct Entry

1 Turn on the component you want the remote control to operate.
2 Look up the brand and code number(s) for the component on the
code list on the following pages.
3 Press and hold the component button that corresponds to the
component you want the remote control to operate (VCR, etc.).
4 Enter the code from the code list.
5 Release the component button.
6 Press
commands. If it doesn't, try pressing the component button and then
ON•OFF
7 If you get no response, repeat these steps using the next code listed for your
brand until the component responds to the remote control commands.
Note: The
Entry method.
How to use the remote control
after you've programmed it
Once the remote control has been programmed successfully, you're ready
to use it to operate other components.
1 Press the component button (
to set the remote control to operate that component.
2 Press
3 Use the remote control buttons that apply to that component.
Note: If you keep pressing buttons and nothing happens, the remote
control is probably in the wrong mode. You must press the component
button that matches the component you want to operate (i.e., if you
want to operate the VCR, press
remote control in VCR mode).
until the component turns off.
PLAY
and wait 2 seconds. Repeat this step until the
REVERSE
to see if the component responds to the remote control
ON•OFF
again.
button can only be programmed using the Direct
AUX
to turn the component on or off.
ON•OFF
again (the red light starts
PLAY
button until the red light on the
STOP
, , ,
TV WebTV VCR AUX
on the remote control to put the
VCR
Device buttons
These are the buttons you use
when you're programming the
remote control to operate
another component. Note: The
DVD button is not programable.
PLAY
, or )
SAT•CABLE
Tip
To stop the automatic
code search without
programming any
components, press
and hold
HOME•CLEAR until
the light on the remote
control turns off.
Tip
Point the remote
control at the
component you want
to operate so the
remote control's signal
can communicate with
the remote-control
sensor on the
component. For
example: If you put the
remote control in VCR
mode, point it at the
VCR, not the TV.
Tip
The buttons might
operate differently for
other components,
especially when you're
using another
component's menu
system.