APRILIA RSV 1000 R FACTORY 2003 Workshop Manual page 77

FUEL SYSTEM
FROZEN PA- Engine load
RAMETERS
Water temperature
Air temperature
Battery voltage
Intake pressure
Vehicle speed
Engine speed
Throttle position
Cylinder 1 dwell point
Engine in VL mode
Cut off active
Status
Frequency
Time since ignition
Driving cycles
Operating time
The following options are available from the adjustable pa-
rameters display :
• throttle position sensor alignment,
•
ECU initialization, including throttle alignment, mini-
mum stepper motor reset and lambda sensor adaptive
parameters reset.
•
ECU initialization, required when a new ECU is in-
stalled
Throttle position alignment must be done whenever the throt-
tle body / ECU is replaced.
• Select function: « Throttle position self-teaching ».
•
Make sure the throttle is fully closed
•
Press ENTER " ".
•
Turn the key to OFF and wait for at least 30 seconds.
ECU initialization must be performed whenever important
engine components (valves, cylinder, camshaft), the exhaust
system, ECU, fuel system or lambda sensor are replaced.
The three self-adaptive correction factors for lambda sensor
control of injection timing are electronically reset.
• Select the function « initialization »
• Make sure the throttle is fully closed
•
Press ENTER " ".
•
Turn the key to OFF and wait for at least 30 seconds.
Initialization enables activation of a new ECU
•
Select function: « ECU initialized ».
• Follow the instructions to enable the new ECU
• Turn the key to OFF and wait for at least 30 seconds.
3 - 10
%
°C
°C
V
approx. 60 kPa
kph
rpm
%
°
no
Not recognized by dashboard
1-2 -
1-0 min
7-8 -
72-72 min
RSV 1000 R - RSV 1000 R FACTORY
lation (activates a set of parameters)
Contrary to the engine parameters dis-
play, here expressed as %
Parameter of little significance, highly
dependent on conditions
Parameter without significance
Number of times error detected by ECU
(including ECU checks at power up, for
certain error types)
Time since ignition for last detection of
error in question
Number of times the engine had been
switched on at the time of detection of
the error in question. The counter re-
sets when the Initialization parameter is
enabled
Total minutes of engine's operation at
the last time the error in question was
detected. The counter does not reset
when the Initialization parameter is en-
abled