Table of Contents
Advertisement
Playing a Tape
Using the Playback Features
Automatic Tracking
Manual Tracking
Time Counter
14
The TV/VCR has automatic tracking which adjusts the
picture when playing a tape that was recorded on
another VCR. Automatic tracking is turned on
whenever a tape is inserted or the TV/VCR's power is
turned on.
Occasionally, you may need to manually adjust
tracking on a tape recorded on a different VCR or
camcorder. Tracking is used when playing a tape. It
has no effect during recording.
• When streaks or snow appear in the picture during
normal playback or slow motion, press TRACK + or –
on the remote or CH
or
best possible picture.
• To turn automatic tracking back on, simultaneously
press and hold both of the CH buttons on the front of
the TV/VCR for 2 seconds.
The time counter helps locate the beginning or end of
programs you taped. The time counter automatically
resets to 0:00:00 whenever a tape is inserted, or you
can press CLEAR when the time counter is displayed.
For example, if a 30-minute program was recorded at
the beginning of the tape and you want to record
another program after it, you should:
1. Insert the pre-recorded tape.
2. Press DISPLAY twice to display the time counter.
0:00:00
Hours
Minutes
Seconds
3. Press FF to fast forward the tape until the time
counter reads 0:30:00.
This is the approximate end of the program and you
can begin recording at this spot. (You will want to
verify this by playing the tape so your recording
begins at the desired spot.)
on the TV/VCR for the
Advertisement
Table of Contents
