Boiler Alert State; Boiler Reset; Turn Off The Operation/Fault Diagnostic Light (Blue) - Worcester Greenstar Si Compact Series User Instructions

CONTROLS

3.1.9 BOILER ALERT STATE

In the event of an alert, a fault code and an alert symbol
light will flash. Refer to the Fault finding section on page 18 or press
227

3.1.10 BOILER RESET

1. To reset the boiler, press
2. "Reset" and are briefly displayed.
▶ If the reset was successful the boiler will return to normal operation.
▶ If the reset was not successful then the alert code will be displayed again, and the blue operation/fault light will continue to flash.
Reset
If the fault remains and cannot be cleared by pressing the reset button, contact Worcester, Bosch Group for
assistance on 0844 892 3000.

3.1.11 TURN OFF THE OPERATION/FAULT DIAGNOSTIC LIGHT (BLUE)

Your new Greenstar boiler is designed to use as little electricity as possible during operation and in stand-by mode. To further
enhance your energy saving during stand-by, you may choose to deactivate the operation/fault diagnostic light. The light will still
flash to alert you to a possible fault, but will not activate during a demand for heat. Please ask your installer to set-up this feature.
12
°C
°F
reset .
°C
°F
2.
will be displayed on the boiler display, and the blue operation/fault
to clear the problem.
reset
eco
°C
reset ok
°F
227
e
min max
eco
°C
reset ok
°F
Reset
1.
e
min max
min
min
Greenstar Si Compact – 6 720 807 278 (2013/05)
2
1 1 3
0 4
bar
max
2
1 1 3
0 4
bar
max
6720643358-09.2Wo