Table of Contents
Advertisement
Item
Description
ECHOMAP Ultra device
GPS antenna
Ignition or in-line switch
NMEA 2000 power cable
NMEA 2000 drop cable
12 Vdc power source
NMEA 2000 terminator or backbone cable
NMEA 2000 T-connector
NMEA 2000 terminator or backbone cable
Installing Locking Rings on the Cables
To help make the cable-routing process easier, some locking rings are packaged separately from the cables.
When installing a cable that does not have a locking ring installed at the factory, you must install the split-collar
locking ring on the cable to ensure a tight connection.
1 Separate the two halves of the locking ring
2 Align the two halves
3 Insert the O-ring
into the end of the connector.
4 After connecting the cable to the port, turn the locking ring clockwise to tighten it.
.
of the locking ring over the cable and snap them together.
7
Advertisement
Table of Contents
