Functional Description; Initial Tool Set Up/ Assembly - Central Pneumatic Professional Laser Series Set Up And Operating Instructions Manual

FunctIOnaL descrIptIOn

Specifications
Maximum Air
Pressure
Air Inlet
Strokes per Minute* 2800 SPM
Air Consumption
Cutting Capacity
Cutter Swivel
Cutting Width
Laser Type
Laser Batteries
* Maximum strokes per minute at stated maximum
air pressure. Excess air pressure is hazardous
and may cause the tool to exceed stated maxi-
mum speed.
InItIaL tOOL set up/
assemBLY
read the entIre ImpOrtant
saFetY InFOrmatIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
unpacking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
SKU 65706
90 PSI
1/4" -18 NPT
9 SCFM @ 90 PSI
18 Gauge sheet steel
360° left or right
7/32" Wide
Output 1 mW, Class II,
Wavelength: 630 - 660 mW
(2) LR44 button cells
For technical questions, please call 1-800-444-3353.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
air supply
dry, regulated, compressed air
to power this tool. do not use
oxygen, carbon dioxide,
combustible gases, or any
other bottled gas as a power
source for this tool.
1. Incorporate an in-line oiler, shut-off
valve, regulator with pressure gauge,
and filter for best service, as shown in
the diagram above. an in-line shut-
off valve is an important safety
device because it controls the air
supply even if the air hose is rup-
tured.
note: If an automatic oiler system is not
used, add a few drops of Pneumatic
Tool Oil directly inside the tool before
tO preVent
expLOsIOn:
use only clean,
Page 7