User Maintenance Instructions; Cleaning, Maintenance, And Lubrication - Central Pneumatic Professional Laser Series Set Up And Operating Instructions Manual

user-maIntenance
InstructIOns
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
accIdentaL OperatIOn:
turn off the tool, detach the
air supply, safely discharge
any residual air pressure in
the tool, and release the
throttle and/or turn the switch
to its off position before
performing any inspection,
maintenance, or cleaning
procedures.
tO preVent serIOus
InjurY FrOm tOOL
FaILure:
do not use damaged
equipment. If abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
tO preVent expLOsIOn:
Lubricate the tool only
with specified lubricants.
Lubricate the air inlet
using only pneumatic tool
oil. Lubricate the internal
mechanism using only
white lithium grease. Other
lubricants may damage the
mechanism and may be
highly flammable, causing an
explosion.
SKU 65706
tO preVent
serIOus InjurY
FrOm
For technical questions, please call 1-800-444-3353.
cleaning, maintenance, and
Lubrication
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the air-operated tool.
1. daily - air supply maintenance:
Every day, perform maintenance on
the air supply according to the com-
ponent manufacturers' instructions.
The lubricator's oil level needs to be
maintained and the moisture filter
must be regularly drained. Performing
routine maintenance on the air sup-
ply will allow the tool to operate more
safely and will also reduce wear on
the tool.
3. Quarterly (every 3 months) - tool
disassembly, cleaning, and In-
spection:
Have the internal mechanism
cleaned, inspected, and lubricated by
a qualified technician. If the vanes
need replacement, all vanes should
be replaced as a set.
4. If the Laser Light ceases to function,
check the Batteries (39). Unscrew
the ON / OFF Switch (40) by turning
it counterclockwise. Drop the Batter-
ies (39) out of the Tube (38). Replace
the batteries, matching the polarity
marked on the Tube. Replace the ON
/ OFF Switch. If the laser light still
does not light, recheck the polarity
positions of the batteries.
Page 11