Polaris RZR XP 1000 High Lifter 2022 Owner's Manual page 155

FOG THE ENGINE
1. Treat the fuel system with POLARIS Carbon Clean or other equivalent fuel
treatment. Follow the instructions on the container. Start the engine. Allow it
to idle for several minutes so the Carbon Clean reaches the injectors. Stop
the engine.
2. Remove the spark plugs and add 2-3 tablespoons of engine oil. To access
the plug holes, use a section of clear 1/4" hose and a small plastic squeeze
bottle filled with the pre-measured amount of oil. Do this carefully! If you miss
the plug holes, oil will drain from the spark plug cavities into the hole at the
front of the cylinder head, and appear to be an oil leak.
3. Reinstall the spark plugs. Torque to specification. See the Spark Plug Gap /
Torque section for details.
4. Apply dielectric grease to the inside of each spark plug cap. Do not reinstall
the caps onto the plugs at this step.
5. Turn the engine over several times. Oil will be forced in and around the
piston rings and ring lands, coating the cylinder with a protective film of fresh
oil.
6. If POLARIS fuel system additive is not used, fuel tank, fuel lines, and
injectors should be completely drained of gasoline.
7. Reinstall the spark plug caps to the spark plugs.
BATTERY MAINTENANCE
See Battery section for storage and charging procedures.
FUSE BOX
Remove the fuse box cover during storage.
STORAGE AREA / COVERS
Be sure the storage area is well ventilated. Cover the vehicle with a genuine
POLARIS cover. Do not use plastic or coated materials. They do not allow
enough ventilation to prevent condensation, and may promote corrosion and
oxidation.
REMOVAL FROM STORAGE
1. Charge the battery if necessary.
2. Make sure the spark plug is tight. Reinstall the fuse box cover if it was
removed for storage.
3. Fill the fuel tank with fuel.
MAINTENANCE
153