Polaris RZR XP 1000 High Lifter 2022 Owner's Manual page 146

MAINTENANCE
LIGHTS
Headlight and taillight lenses become dirty during normal operation. Clean all
lights frequently to ensure a clear field of vision as well as visibility to other
vehicles.
If an LED headlamp has moisture or fogging inside, disconnect the wiring
harness from the headlamp(s) for a few days to allow the moisture to clear out.
TAILLIGHT / BRAKE LIGHT REPLACEMENT
The taillight assembly is not serviceable. If the taillight or brake light fails to
operate properly, replace the entire taillight assembly.
HEADLIGHT REPLACEMENT
If a headlight becomes damaged or inoperable, the entire headlight assembly
must be replaced. Do not operate this vehicle at night or in low light conditions
until the headlight is replaced. Always make sure lights are adjusted properly for
best visibility.
HEADLIGHT BEAM ADJUSTMENT
The headlight beam can be adjusted slightly upward or downward and to the left
or right.
1. Position the vehicle on a level surface. The headlight should be
approximately 25 ft. (7.6 m) from a wall.
2. Place the transmission in PARK.
3. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
4. Apply the brakes. Start the engine. Turn the headlights to high beam.
144
TIP