Table of Contents
Advertisement
Do not make any adjustments whilst the saw blade is
in motion.
Always make sure the power plug has been
removed from the mains power source before
making adjustments, lubricating or when doing any
maintenance on the product.
Before and after each use, check the product for
damage or broken parts. Keep the product in top
working condition by immediately replacing parts with
spares approved by the manufacturer.
The blade is very hot after use, wear gloves or allow to
cool before maintenance or cleaning procedures.
Clean out accumulated dust using a brush or vacuum
cleaner. Do not use compressed air.
To assure safety and reliability, all repairs, including
changing brushes, should be performed by an
authorised service centre.
If the power supply cord is damaged, it must be
replaced only by the manufacturer or by an authorised
service centre to prevent damage to the saw or risk of
electrocution.
WARNING
For greater safety and reliability, all repairs should be
performed by an Authorised Ryobi Service Centre.
Maximum cutting depth stop
blade from cutting into the metal base of the unit.
WARNING
TRANSPORTATION AND STORAGE
When storing the product, disconnect the power
cord. Store the product in a secure place that is not
accessible to children. Store the power cord as shown
in the illustration on page 31 - 32 of this manual.
Clean the product using a brush and vacuum cleaner
before storage.
If you remove the saw blade or keep spares with
the unit, ensure they are in the original packaging to
prevent injury.
To secure the product prior to movement:
The product should be stored at the zero degree mitre
and bevel angle and locked in position. The slide
should be locked. The handle should be locked in the
lower (safe) position with the guards closed.
One or both sides of the work piece supports can be
removed for ease of carrying.
To move or transport in a vehicle:
Secure the product prior to movement as described in
the manual.
Remove the product from the bench top by releasing
the 4 bolts, one at each corner. Secure the bolts for
future use. Lift the product using the handle at the top.
When lifting to a height, two persons wearing heavy
gloves are needed to lift the base of the product.
When transporting in a vehicle, set the product on its
base and secure against movement.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety alert
CE conformity
Please read the instructions carefully before
starting the machine.
Class II tool, double insulation
Wear ear protection
Always wear eye protection.
Danger! Sharp blade.
Wear safety gloves
Blade rotation direction (shown on saw blade)
Blade rotation direction (shown on blade
guard)
Blade width of cut (Kerf)
Safety
5
Advertisement
Table of Contents
