Table of Contents
Advertisement
4.
Release the slot cover retention latch that secures the slot covers by lifting the tab on the latch and
rotating the latch to the open position.
5.
Before installing an expansion card, remove the expansion slot cover or the existing expansion card.
NOTE:
the expansion card.
a.
If you are installing an expansion card in a vacant socket, remove the appropriate expansion slot
cover on the back of the chassis. Pull the slot cover straight up then away from the inside of the
chassis.
28
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
Before removing an installed expansion card, disconnect any cables that may be attached to
Advertisement
Table of Contents
