Pc With Wi-Fi Adapter - D-Link DSL-2750U User Manual

DSL-2750U Wireless N300 ASDL2+ Router with Ethernet WAN Support
User Manual

PC with Wi-Fi Adapter

1. To connect the device to a DSL line: connect a phone cable between the DSL port of the
router and the ADSL OUT port of the splitter. Connect your phone to the PHONE port of
the splitter. Then connect another phone cable between a phone jack and the ADSL IN port
of the splitter.
2. To connect the device to an Ethernet line: please connect the router to the ISP's Ethernet
line only after setting the WAN port and creating the Internet connection (see the Initial
Configuration Wizard section, page 32).
3. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
4. Turn on the router by pressing the ON/OFF button on its back panel.
5. Make sure that your Wi-Fi adapter is on. As a rule, modern notebooks with built-in wireless
NICs are equipped with a button or switch that turns on/off the wireless adapter (refer to
your PC documents). If your PC is equipped with a pluggable wireless NIC, install the
software provided with your Wi-Fi adapter.
Then make sure that your Wi-Fi adapter is configured to obtain an IP address automatically (as
DHCP client).
Page 21 of 173
Installation and Connection