Table of Contents
Advertisement
connected device is compatible with display for the
feature.
Surround Sound
Settings > Display & Sound > Sound > EasyLink
2.0 > Surround Sound.
Select a surround effect from the preset types.
• Upmix - Upmix to take full advantage of all speakers.
• Standard - Speakers output follow the original
channels.
• Surround AI - Optimum surround effect using AI
analysis.
DRC
Settings > Display & Sound > Sound > EasyLink
2.0 > DRC.
Select the preferred Dynamic Range Control (DRC).
• Auto - Dynamic range is automatically adjusted.
• On - Optimize the dynamic range.
• Off - Turn off dynamic range adjustment.
Height speakers
Settings > Display & Sound > Sound > EasyLink
2.0 > Height speakers.
Select the preferred height speakers movement. The
setting is only available when connected device is
compatible with display for the feature.
• Auto - Dynamic movement follow contents.
• On - Always elevated.
• Off - Flat position.
Select sound stage
Settings > Display & Sound > Sound > EasyLink
2.0 > Sound stage.
Select a listening experience. The setting is only available
when connected device is compatible with display for
the feature.
• Auto - Dynamic setting follow contents.
• On - Immersive Sound Stage, good for watching
movies.
• Off - Crystal Sound Stage, good for listening to music
and dialog.
Reset all to default
Settings > Display & Sound > Sound > EasyLink
2.0 > Reset all to default.
Reset all the EasyLink 2.0 sound settings back to the
original factory settings.
Room Calibration
Room calibration
Settings > Display & Sound > Sound > Room
calibration.
This calibration will allow the display to determine the
acoustics in your room and provide optimized sound
quality on the display speakers that best match the
acoustics.
You need to pair your remote control with the display
before starting the setup and make sure
the display Audio out setting is Display speakers. For a
more accurate result, please keep the room quiet.
To start the room calibration:
1 - Hold your remote control at the listening position and
point it towards the display during the tuning process.
2 - Select Calibrate now or Calibrate again to start the
calibration.
3 - A test sound will be played and measured through
your remote control. Hold your remote control and point
it towards the display, this can take several seconds.
4 - Once your display speakers are successfully calibrated,
select Test to listen to the sound before and after
the display speakers are calibrated. Select Apply to
accept the setting or select Try again to redo the
calibration.
5 - When room calibration setup is successful and
applied, display shall return to the Settings menu. Now
go to Settings > Display & Sound > Sound > Room
calibration and select Apply calibration to tune the
audio output from display speakers.
Advanced Sound Settings
Volume Control
Auto volume
Settings > Display &
Sound > Sound > Advanced > Auto volume.
Select On or Off to switch on or off the auto volume
adjustment.
Select Night Mode for a more comfortable quiet
listening experience.
Delta volume
Settings > Display &
Sound > Sound > Advanced > Delta volume.
The Delta volume setting can be used to adjust to
balance the sound level difference between the program
and the HDMI source input. Press the Arrow /
navigation keys to adjust the delta value for display
speaker volume.
29
Advertisement
Table of Contents
