Table of Contents
Advertisement
3.4. IR Sensor
The display can receive commands from a remote control
that uses IR (infrared) to send commands. If you use such
a remote control, always make sure you point the remote
control at the infrared sensor on the front of the display.
Warning
Do not put any objects in front of IR sensor of the display,
it may block the IR signal.
3.5. Batteries and Cleaning
Replace batteries
Refer to the Quick Start Guide in your product package
for detailed information about the remote control
batteries.
If the display does not react on a key press on the remote
control, the batteries might be empty.
To replace the batteries, open the battery compartment
on the back of the remote control.
1 - Slide the battery door in the direction shown by the
arrow.
2 - Replace the old batteries with new batteries. Make
sure the + and the - ends of the batteries line up
correctly.
3 - Reposition the battery door and slide it back until it
clicks.
• Remove the batteries if you are not using the remote
control for a long time.
• Safely dispose of your old batteries according to the
end of use directions.
Cleaning
Your remote control is treated with a scratch-resistant
coating.
To clean the remote control, use a soft damp cloth. Never
use substances such as alcohol, chemicals or household
cleaners on the remote control.
10
Advertisement
Table of Contents
