Initial Configuration; Airzone Blueface Zero And Think Thermostats - Daikin Airzone EazyZone AZEZ6DAIST07 Quick Installation Manual

Table of Contents

Available languages

INITIAL CONFIGURATION

Important: Once the setup has been started, it must conclude. You will be able to modify the desired parameters later.

Language/Country

Select your language and country. These are the available languages: Spanish, English, French, Italian, German and Portuguese.

To associate a wireless Think thermostat, start the radio channel search:

Setting wireless device

Open the radio channel. To do that, press on SW1. The LED D19 will remain solid red. Once

open, you have 15 minutes to make the association. If that period of time expires, start the

process over again. Remember not to open more than one module at the same time, it may

alter the process. You can also open the channel association radio through the Blueface zero

and Think (see section System parameters).

IMPORTANT: not to open more than one radio channel at the same time, it may alter the

process.

Start the radio channel search, to do so, press Airzone to start the search.

Verify the range is correct (30% minimum) and confirm.

Zone address

Select the zone associated to the thermostat. Each zone corresponds to a radiant element relay output. For example, zone 1

will control the relay output O1 of the Airzone Control module of radiant elements (AZCE6OUTPUT8).

Associated outputs

If necessary, the system allows you to associate more than one control output to a zone. It is possible to control multiple outputs

from the same thermostat.

Thermostat configuration

Select the operation of the thermostat:

Master: Controls all the parameters of the installation.

Zone: Controls all the parameters of the zone.

Control stages (only for installations with AZCE6OUTPUT8 module)

Select the stages to be controlled: Air, Radiant or Combined.

Other settings

Press to conclude the initial setup procedure, or access the advanced settings menu (system address, stages of control, etc.) to

change any other setting. Activate the basic function if required (see Advanced Settings, Zone Parameters).

Table of Contents

Table of Contents