Zone Reset; System Reset; Changing Batteries; Assembly And Connection Evaluation - Daikin Airzone EazyZone AZEZ6DAIST07 Quick Installation Manual

ES
EN
FR

Zone reset

IT
If needed, to reset a zone follow the steps shown in the section Advanced Settings, Zone Parameters for Blueface zero and Think
thermostats and the section Lite thermostat Reset if using Lite thermostats.
PT

System reset

DE
If you want to return to factory values, press and hold SW1 until LED D19 stops blinking. Wait for the LEDS
to go back to their normal state before starting with the initial configuration process.

Changing batteries

To replace the battery, separate the thermostat from its support and
replace the battery (CR2450).
Important:
We recommend using of top-brand batteries. Using low-quality
batteries may reduce the duration of use
Remember to deposit the old battery into an appropriate recycling point.
Note: Do not forget to remove the security system before taking away the
thermostat from the wall.

ASSEMBLY AND CONNECTION EVALUATION

Check the following aspects:
- The state of the LEDs of the main control board and the
rest of control elements. Check the self-diagnose section
of the data sheet of the elements.
- Main control board LEDs of opening dampers light up
sequentially.
- Wired and wireless thermostats power supply.
Important: In the Main Control Board, check the correct
performance of D3, D11 and D19 LEDs and motorized
elements.
Main control board
D3
Main control board power
D11
D19 Association channel active
Open dampers
Close dampers
26
.
Meaning
Blinking
activity
Solid
Solid
Solid
Solid
Green
Red
Red
Green
Red